No worries, we’re here to support. Just get in touch with us and we will help you by all means.
In order to benefit from the logic of the PATCHBOX system we recommend to install the PATCHBOX unit either above or below the switch and using two Patchcatches for each patch panel.
Release the rail’s fastening screw. Insert rail into the cabinet resting the rail’s rear pegs in the cabinets mounting holes. Extend the rail to fit the depth of the cabinet and fasten the rail’s screw.
Mount the Setup.exe securing the weight of equipment, such as switches until they are securely screwed in. Click here to find out more.
Slide the PATCHBOX onto the mounting rails leaving a small gap between the 19” rail and the unit for the Patchcatch in Step 5.
One on either side of the unit the PATCHBOX Patchcatch is placed between the PATCHBOX Frame and the 19” rail.
Using the supplied hex nuts secure the PATCHBOX into the network cabinet.
Print and insert your printed ID labels into the face of each PATCHBOX Cassette. Click here for a print document template.
Having released the cable stopper, pull out one end of the desired catch cord.
Pull out patch cord with enough overlength to span from the desired port to the PATCHBOX.
Connect the patch cord to the desired port.
Guide the patch cord through the PATCHBOX Patchcatches along the side of the cabinet.
It’s important to always patch from top to button inorder to to have the ability to feed overlength cable back into the cassette.
Allow any excess patch cord to be pulled back into the cassette and then activate the cable stopper.
Pull / wiggle one end of a patch cord and immediately identify the other end of the patch cord by its movement.